Grass Valley Newton Modular Control System v.2.0 - Manual (Page 60)

60 Newton Instruction Manual
Section 3 — Configuration
You can rename or delete the assignment that now appears in the
Current Configuration area by right-clicking anywhere on the high-
lighted control area and selecting
Rename and entering a new name or
choosing Delete ( Figure 43 ).
Figure 43. Rename or Delete Knob Assignment
8. Change the name of the vciGain control to Input_Gn_1 .
9. Highlight the Input Video Gain vciGain2 control in the Module area and
associate it to the Configure Knob 2 button or right-click to bring up the
knob menu. Change the name to Input_Gn_2 .
10. Do the same for vciGain3 and vciGain4 controls associating them to
Knob 3 and Knob 4 respectively.
11. This will result in the Newton Panel Configurator screen as shown in
Figure 44 . Note that the label names in the list have been renamed.
Figure 44. Sample Configuration Example – First Setup
Label names have
been changed