Grass Valley Newton Modular Control System v.2.0 - Manual (Page 66)

66 Newton Instruction Manual
Section 3 — Configuration
Soft Keys – Recall Channel Setup Mode
The assignment of soft keys for setup recall can be made from the Newton
Panel Configurator during the configuration process and sent to a panel or
made at a panel and sent back to the Newton Panel Configurator.
To delegate soft keys to specific setups using the Newton Panel Configu-
rator:
1. Select the Soft Key Configuration tab in Newton Panel Configurator
(
Figure 50 on page 67 ).
2. Select a Soft Key to be assigned by checking the corresponding
checkbox to activate the Soft Key functions. Soft Keys 1-4 are used for
this example.
3. From the Soft Key list, open the Soft Key 1 Channel pulldown and select
Sat_4.
Note In the Channel pulldown, the Sat_4 channel will be the only choice since this
configuration has only one channel.
4. In the Setup pulldown, select a setup from the list to assign to this soft
key. The Video_Proc_Input_Gains setup will be delegated to Soft Key 1
in this example.
5. Continue to delegate using Soft Keys 2, 3, and 4 for the example to the
Video_Proc_Horiz_Timing, Vertical_Timing, and Brightness_Y Offset
setups respectively as shown in
Figure 50 on page 67 .
6. When this configuration is saved and downloaded to a panel, Soft Keys
1-4 will bring up the corresponding setups when pressed and the
Recall
button is on.