Grass Valley Newton Modular Control System v.2.0 - Manual (Page 42)

42 Newton Instruction Manual
Section 3 — Configuration
Enable Router Interface on Rack Mount Panel
Select the Panel Options link to enable the Newton Router Interface option on
this rack mount panel. This will bring up the Newton Router Interface
Option web page (
Figure 25 ).
A software License Key is required to enable the option. For a NewtonRM
panel shipped from the factory with the option, you will receive a License
Key form with the code you must enter to enable the option.
If you are updating a panel in the field and adding the option, you will
need to first update to version 2.0 software then acquire the Device ID of
the panel (
Figure 25 ) in order to receive a License Key from the factory.
Record this number from the panel you wish to run the option on and
contact Customer Service to obtain the License Key. Refer to Contacting
Grass Valley
on page 2 for contact information.
Note When the Newt-Route option is ordered, a License Key form should accom-
pany the option when it is shipped. describing how to obtain the License Key.
1. To enable the Router Interface option, select the Enter License Key button.
Figure 25. Newton Panel Options Web Page
2. In the screen that comes up, enter the License Key code provided from
Grass Valley in the blank field and press the
Submit button ( Figure 26 ).
Figure 26. Enter License Key
Device ID