Grass Valley Newton Modular Control System v.2.0 - Manual (Page 18)

18 Newton Instruction Manual
Section 1 — Newton Overview
NetConfig Application
With the NetConfig application installed, in addition to using Newton
Panel Configurator required to configure the Newton panels, the PC can be
used to set IP addresses of panel and modular frame devices on the
network and update software to frame controllers and media modules
when updates become available. Because the NetConfig application runs
over the network, it centralizes and accelerates configuration tasks. It elim-
inates the need to physically visit every frame in the network, attach a
serial cable, and load parameters. Everything can be done from your
desktop. Refer to
Figure 3 for an illustration of the NetConfig main view.
NetConfig also interfaces with many of the Grass Valley router control sys-
tems, and various other Grass Valley products.
Figure 3. NetConfig Main View