Grass Valley Newton Modular Control System v.2.0 - Manual (Page 100)

100 Newton Instruction Manual
Section 4 — Operation
Rack Mount Panel – Soft Key Router Source Assignment
To make soft key source assignments from the rack mount panel:
1. On the Newton rack mount panel ( Figure 87 ), select the Route button to
bring up the Preset Source mode.
2. Rotate the fourth knob (yellow LED) to bring up the preset source (in
brackets) you wish to delegate to a soft key.
3. Assign this displayed source to a soft key by holding down the
Learn/Recall button until the display shows the Press the soft key for PST
router source message (not shown).
Figure 87. Delegate Router Source to Soft Keys at Rack Mount Panel
4. Press the desired soft key to assign to this router source. The display
will return to the Preset Source mode.
5. Select a different router source, then press the Recall button and the soft
key to verify the correct router source is recalled.
Video
In Gain
Video
HTimg
V
Timing
Bright
Y OFF
Learn/
Recall
Enable
Ident NEWTON
MODULAR CONTROL 8234_00_12
Router
Route
Mon
D_DST_2
[D_DST_2]
Monitored Dest:
[ Monitoring PST ]
Dst11
[ Dst12 ]
Route button Learn button Rotate third knob with yellow LED
SRC
DEST
SRC11
Dst1
[ PST SRC ] [ SRC20 ]