Grass Valley Newton Modular Control System v.2.0 - Manual (Page 79)

Newton Instruction Manual 79
Panel Configuration
Figure 65. Copy and Paste Setup Names into New Channel
This will paste the setup names from the Sat_4 channel into the new
Sat 4_Decoder_2 channel. The corresponding controls from the new
module will now have to be assigned for each of these setups.
• Delete – deletes the entire channel and all associated setups.
Adding or Revising Setups
Setups can be added or revised in a channel using the Configurator.
To add a setup to a channel:
1. With the configuration present in the Newton Panel Configurator
screen, highlight the channel to add the setup to and select the
New Setup
button.
2. Name the setup and create knob assignments as desired with Newton
Panel Configurator.
Up to twelve setups can be present in a single channel.
To revise a setup:
You can rename a setup, reposition the name up or down in the setup list,
or delete a setup by right-clicking on the setup name in the Newton Panel
Configurator window to bring up the menu shown in
Figure 64 on page 78 .
Save Configuration After Changes
After any changes, be sure to resave the new configuration to the
10pm_News file and download it to the panel again for changes to be
reflected on the panel.