Grass Valley K2 Media Client System Guide v.3.3 - Manual (Page 95)

June 9, 2009 K2 Media Client System Guide 95
Installing Pathfire Transfer Service software
Install DMG Transfer Service software
Prerequisites for this procedure are as follows:
• The first DMG Master software and the second DMG Master software is installed
on the K2 Media Client or K2 Media Server.
Transfer Service has the capability to transfer HD content and SD content. However,
HD does not transfer to a SD destination nor does SD transfer to a HD destination.
Therefore, if both types of content flow through the Transfer Service process, they
each require their own destination.
1. If you have any files in C:\temp that you want to save and you have not already
done so, copy the files to a different location.
2. If you have not already done so, place the Transfer Service CD in the CD-ROM
drive of the K2 Media Client or K2 Media Server.
3. On the CD, open DMGTRANSFER.exe.
InstallShield Wizard opens and extracts files, then the Pathfire Digital Media
Gateway Installation program opens.
4. In the Information window, click Next .
5. In the Type window, select Server Connect for Programming and then click Next .
6. In the Destinations window, select Configure destination one and then click Next .
If SD and HD destinations are required, configure the SD first.
7. In the Enter Text window, type the name of the K2 Media Client or K2 Media
Server on which you are now installing the Pathfire software.
This name does not have to match any DNS names or computer names. However,
it should be a name that is recognized when working in the Destinations window
of the Pathfire DMG application.
8. In the Destinations window, click Next .
9. In the next Enter Text window, type a description that applies to the K2 Media
Client or K2 Media Server on which you are now installing the Pathfire software,
and then click
Next .
10.In the Transfer Engine window, select DirectConnect and then click Next .
11.In the Video Resolution window, select the video resolution for this destination. If
SD and HD destinations are required, configure destination one for SD and
destination two for HD. Then click
Next .
The Enter default output directory window dialog box opens.
12.Enter the path that specifies the K2 Pathfire capture service watched folder and
then click OK .
In the K2 Capture Services utility, this watched folder is labeled the Source
Directory.
13.In the Destinations window, do one of the following:
• If you require another destination (such as the HD destination), select Configure
destination two and click Next . Repeat previous steps to configure the