Grass Valley K2 Media Client System Guide v.3.3 - Manual (Page 234)

234 K2 Media Client System Guide June 9, 2009
Appendix D Rack mounting
Rack mount hardware shipped with the K2 client system
Your K2 client system rack-mount kit comes with rack mounting hardware as shown.
NOTE: You must in-
stall chassis section
on the K2 Media Client
chassis
Automatic
Latches
Rack Section
10-32 PHS
Screw
10-32 PHS
Screw
Flat
Nut
Bars
Flat Nut Bar
Intermediate
Section
Stop Latch
Hole
Rear
Mounting
Stationary
Section
NOTE: Right- hand and left-hand stationary section is
designated by the RH and the LH ma rked on the rails.
Stop latch holes should be towards
the bottom when slides are in place. (The right-hand rail is shown
above.)
Mounting Brackets