Grass Valley K2 Media Client System Guide v.3.3 - Manual (Page 94)

94 K2 Media Client System Guide June 9, 2009
Chapter 3 System connections and configuration
3. On the CD, open DMGMASTER40IT79.exe. The name of this file might change
slightly, depending on the version of Pathfire Transfer Service software.
InstallShield Wizard opens and extracts files for two sets of data. The entire
extracting process is less than 3 minutes. When the process completes, the Pathfire
Digital Media Gateway Installation program opens and runs.
4. When the Welcome to the InstallShield Wizard for DMG window displays, click
Next to progress through the wizard.
5. When you arrive at the License Agreement window, click Yes .
6. In the Installation Type window, select Station Integration (3xx, 6xx) and then click
Next .
7. In the Enter Text window, enter the IP address of the Pathfire DMG Receive Server
from which you are pulling content as input for the K2 Pathfire capture service.
If an IP address is already entered, it is the IP address of the server as detected from
a previous install.
8. Once the IP address of the Pathfire DMG Receive Server is correctly entered, click
Next .
A series of message boxes display for approximately twelve minutes as the
necessary “skins” are installed. Once completed, the DMG Install Complete dialog
box displays.
9. In the DMG Install Complete dialog box, respond as appropriate to restart and
allow the K2 Media Client or K2 Media Server to restart.
10.Continue with the next procedure “Install second DMG Master software” .
Install second DMG Master software
Prerequisites for this procedure are as follows:
• The first DMG Master software is installed on the K2 Media Client or K2 Media
Server.
1. If you have any files in C:\temp that you want to save and you have not already
done so, copy the files to a different location.
2. If you have not already done so, place the Transfer Service CD in the CD-ROM
drive of the K2 Media Client or K2 Media Server.
3. On the CD, open DMGMASTER.exe.
InstallShield Wizard opens and extracts files.
The Pathfire Digital Media Gateway Installation program opens and runs
installation processes. This takes approximately two minutes. When installation
processes are complete, the DMG Install Complete dialog box displays.
4. In the DMG Install Complete dialog box, respond as appropriate to restart and
allow the K2 Media Client or K2 Media Server to restart..
5. Continue with the next procedure “Install DMG Transfer Service software” .