Grass Valley K2 Media Client System Guide v.3.3 - Manual (Page 130)

130 K2 Media Client System Guide June 9, 2009
Chapter 5 Managing K2 client system software
6. Create a backup image using the K2 Media Client Recovery CD. Refer to the K2
Media Client Service Manual.
Installing K2 software
Except as noted in the preceding sections, when you receive your K2 Media Client,
you do not need to install software. The system has the most recent software
pre-installed at the factory.
If you are upgrading software on a K2 Media Client, refer to the K2 Release Notes for
that version of software for specific upgrade procedures. If you are upgrading shared
storage (SAN) K2 Media Clients, you must use the proper sequence and upgrade all
K2 Media Servers and K2 Media Clients to the same software version. Upgrade K2
Media Servers first, then K2 Media Clients. Refer to K2 Release Notes for the
complete explanation of the rules that apply to upgrading software on the K2 Storage
System.
Before upgrading K2 software, you should make a recovery disk image. Refer to the
K2 Media Client Service Manual for disk image information.
Re-installing Grass Valley software
Follow these instructions if you need to re-install software. If you are upgrading to a
new release version, see the Release Notes for the latest information on installation
procedures. For more information on recovery procedures, see
“Backup and recovery
strategies” on page 132 .
At the opening screen of the install wizard, select Repair , then use the following
instructions for the type of software you are installing: