Configuring the digest snooping feature, Digest snooping configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 89
79
Configuring the Digest Snooping feature
You can enable Digest Snooping only on the H3C device that is connected to a third-party device that
uses its private key to calculate the configuration digest.
To configure Digest Snooping:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view or port group
view.
•
Enter Ethernet interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
Use either command.
3.
Enable Digest Snooping on the
interface or port group.
stp config-digest-snooping
Disabled by default.
4.
Return to system view.
quit
N/A
5.
Enable global Digest Snooping.
stp config-digest-snooping
Disabled by default.
CAUTION:
•
With the Digest Snooping feature enabled, comparison of configuration digest is not needed for
in-the-same-region check, so the VLAN-to-instance mappings must be the same on associated ports.
•
With global Digest Snooping enabled, modification of VLAN-to-instance mappings and removing of
the current region configuration using the undo stp region-configuration command are not allowed.
You can only modify the region name and revision level.
•
You must enable Digest Snooping both globally and on associated ports to make it take effect. To make
the configuration effective on all configured ports and reduce impact on the network, enable Digest
Snooping on all associated ports first and then globally.
•
To prevent loops, do not enable Digest Snooping on MST region edge ports.
•
H3C recommends you to enable Digest Snooping first and then the spanning tree feature. To avoid
traffic interruption, do not configure Digest Snooping when the network works well.
Digest Snooping configuration example
Network requirements
As shown in
, AC 1 and AC 2 connect to Device C, which is a third-party device, and all these
devices are in the same region.
Enable Digest Snooping on AC 1's and AC 2's ports that connect to Device C, so that the three devices
can communicate with one another.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points