H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 34)

24
Table 3 Ethernet interface configuration prerequisites
Hardware Ethernet interface configuration prerequisites
Access controller modules (installed in a switch)
LSQM1WCMB0
LSQM1WCMD0
LSBM1WCM2A0
LSRM1WCM2A1
LSRM1WCM3A1
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot slot-number command.
LSWM1WCM10
LSWM1WCM20
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot 1 slot-number system system-name command.
Wireless switches
WX3024E
Use the oap connect slot 0 command on the access controller engine to log
in to the switching engine.
Access controllers
WX6103
Use the oap connect slot 0 command on the active main control board to log
in to the switch interface board.
WX5002
WX5004
You configure GE interfaces on the access controller.
As shown in Figure 7 :
• Host A and Host C belong to Department A, and access the enterprise network through different
devices. Host B and Host D belong to Department B, and access the enterprise network through
different devices.
• To ensure communication security and avoid broadcast storms, VLANs are configured in the
enterprise network to isolate Layer 2 traffic of different departments. VLAN 100 is assigned to
Department A, and VLAN 200 is assigned to Department B.
• Make sure that hosts within the same VLAN can communicate with each other. Host A can
communicate with Host C, and Host B can communicate with Host D.
Figure 7 Network diagram
Configuration procedure
1. Configure AC 1:
# Create VLAN 100, and assign port GigabitEthernet 1/0/2 to VLAN 100.
GE1/0/3 GE1/0/2
Host A Host C Host B Host D
AC 1
VLAN 100 VLAN 100 VLAN 200 VLAN 200
AC 2
GE1/0/2 GE1/0/3
GE1/0/4 GE1/0/4