H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 35)

25
system-view
[AC1] vlan 100
[AC1-vlan100] port gigabitethernet 1/0/2
[AC1-vlan100] quit
# Create VLAN 200, and assign port GigabitEthernet 1/0/3 to VLAN 200.
[AC1] vlan 200
[AC1-vlan200] port gigabitethernet 1/0/3
[AC1-vlan200] quit
# Configure port GigabitEthernet 1/0/4 as a trunk port, and assign it to VLANs 100 and 200,
enabling GigabitEthernet 1/0/4 to forward traffic of VLANs 100 and 200 to AC 2.
[AC1] interface gigabitethernet 1/0/4
[AC1-GigabitEthernet1/0/4] port link-type trunk
[AC1-GigabitEthernet1/0/4] port trunk permit vlan 100 200
Please wait... Done.
2. Configure AC 2 as you configure AC 1.
3. Configure Host A and Host C to be on the same IP subnet, for example, 192.168.100.0/24.
Configure Host B and Host D to be on the same IP subnet, for example, 192.168.200.0/24.
Verification
1. Host A and Host C and ping each other successfully, but they both fail to ping Host B. Host B and
Host D and ping each other successfully, but they both fail to ping Host A.
2. Check whether the configuration is successful by displaying relevant VLAN information.
# Display information about VLANs 100 and 200 on AC 1.
[AC1-GigabitEthernet1/0/4] display vlan 100
VLAN ID: 100
VLAN Type: static
Route Interface: not configured
Description: VLAN 0100
Name: VLAN 0100
Broadcast MAX-ratio: 100%
Tagged Ports:
GigabitEthernet1/0/4
Untagged Ports:
GigabitEthernet1/0/2
[AC1-GigabitEthernet1/0/4] display vlan 200
VLAN ID: 200
VLAN Type: static
Route Interface: not configured
Description: VLAN 0200
Name: VLAN 0200
Broadcast MAX-ratio: 100%
Tagged Ports:
GigabitEthernet1/0/4
Untagged Ports:
GigabitEthernet1/0/3