H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 128)

118
[BAS] interface Ten-GigabitEthernet0/0.100
[BAS-Ten-GigabitEthernet0/0.100] vlan-type dot1q vid 100 second-dot1q 1001
[BAS-Ten-GigabitEthernet0/0.100] ip address 10.1.1.1 255.255.255.0
[BAS-Ten-GigabitEthernet0/0.100] quit
# Configure IP address pool 2 to assign IP addresses 20.1.1.0/24 to clients.
[BAS] dhcp server ip-pool 2
[BAS-dhcp-pool-2] network 20.1.1.0 mask 255.255.255.0
[BAS-dhcp-pool-2] gateway-list 20.1.1.1
[BAS-dhcp-pool-2] quit
# Configure QinQ termination on Ten-GigabitEthernet 0/0.200 to terminate packets whose Layer 1
VLAN IDs are 200 and Layer 2 VLAN IDs are 2001.
[BAS] interface Ten-GigabitEthernet0/0.200
[BAS-Ten-GigabitEthernet0/0.200] vlan-type dot1q vid 200 second-dot1q 2001
[BAS-Ten-GigabitEthernet0/0.200] ip address 20.1.1.1 255.255.255.0
# Enable local proxy ARP on BAS, so that clients which are isolated at Layer 2 can communicate at Layer
3 (clients in the same VLAN can communicate through only BAS).
[BAS-Ten-GigabitEthernet0/0.200] local-proxy-arp enable
[BAS-Ten-GigabitEthernet0/0.200] quit
Expected results
• AP can get an IP address on network segment 10.1.1.0/24. Both AP and AC can ping BAS at
10.1.1.1.
• AP can be successfully associated with the AC. When ARP is disabled on AC, AC can ping AP.
• When the clients log in , they can get IP addresses on network segment 20.1.1.0/24. Clients can
ping BAS at 20.1.1.1.
• When multiple clients log in, clients can communicate through only BAS.