H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 47)

37
Hardware Ethernet interface configuration prerequisites
LSQM1WCMB0
LSQM1WCMD0
LSBM1WCM2A0
LSRM1WCM2A1
LSRM1WCM3A1
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot slot-number command.
LSWM1WCM10
LSWM1WCM20
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot 1 slot-number system system-name command.
Wireless switches
WX3024E
Use the oap connect slot 0 command on the access controller engine to log
in to the switching engine.
Access controllers
WX6103
Use the oap connect slot 0 command on the active main control board to log
in to the switch interface board.
WX5002
WX5004
You configure GE interfaces on the access controller.
Network requirements
As shown in Figure 9 :
• The MAC address of Host A is 000f-e235-dc71 and belongs to VLAN 1. It is connected to
GigabitEthernet 1/0/1 of the device. To prevent MAC address spoofing, add a static entry to the
MAC address table of the device for the host.
• The MAC address of Host B is 000f-e235-abcd and belongs to VLAN 1. Because this host once
behaved suspiciously on the network, you can add a destination blackhole MAC address entry for
the MAC address to drop all packets destined for the host.
• Set the aging timer for dynamic MAC address entries to 500 seconds.
Figure 9 Network diagram
Configuration procedure
# Add a static MAC address entry.