H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 28)

18
[AC-vlan10] port gigabitethernet 1/0/2
[AC-vlan10] quit
# Create VLAN-interface 5 and configure its IP address as 192.168.0.10/24.
[AC] interface vlan-interface 5
[AC-Vlan-interface5] ip address 192.168.0.10 24
[AC-Vlan-interface5] quit
# Create VLAN-interface 10 and configure its IP address as 192.168.1.20/24.
[AC] interface vlan-interface 10
[AC-Vlan-interface10] ip address 192.168.1.20 24
[AC-Vlan-interface10] return
2. Configure the default gateway of PC A as 192.168.0.10.
3. Configure the default gateway of PC B as 192.168.1.20.
Verifying the configuration
1. The PCs can ping each other.
2. Display brief information about Layer 3 interfaces on the AC to verify the configuration.
display ip interface brief
*down: administratively down
(s): spoofing
Interface Physical Protocol IP Address Description
Vlan-interface5 up up 192.168.0.10 Vlan-inte...
Vlan-interface10 up up 192.168.1.20 Vlan-inte...
Configuring port-based VLAN
Introduction to port-based VLAN
Port-based VLANs group VLAN members by port. A port forwards traffic for a VLAN only after it is
assigned to the VLAN.
Port link type
You can configure the link type of a port as access, trunk, or hybrid. The link types use the following
VLAN tag handling methods:
• An access port belongs to only one VLAN and sends traffic untagged. It is usually used to connect
a terminal device unable to recognize VLAN tagged-packets or when there is no need to separate
different VLAN members. As shown in Figure 6 , Device A is connected to common PCs that cannot
recognize VLAN tagged-packets, and you must configure Device A's ports that connect to the PCs
as access ports.
• A trunk port can carry multiple VLANs to receive and send traffic for them. Except traffic of the port
VLAN ID (PVID), traffic sent through a trunk port will be VLAN tagged. Usually, ports connecting
network devices are configured as trunk ports. As shown in Figure 6 , Device A and Device B need
to transmit packets of VLAN 2 and VLAN 3, and you must configure the ports interconnecting
Device A and Device B as trunk ports and assign them to VLAN 2 and VLAN 3.
• Like a trunk port, a hybrid port can carry multiple VLANs to receive and send traffic for them. Unlike
a trunk port, a hybrid port allows traffic of all VLANs to pass through VLAN untagged. Usually,
hybrid ports are configured to connect devices whose support for VLAN tagged-packets you are
uncertain about. As shown in Figure 6 , Device C connects to a small-sized LAN in which some PCs