Protocols and standards, Qinq configuration task list – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 124
114
Table 15 Reserved protocol type values
Protocol type Value
ARP 0x0806
PUP 0x0200
RARP 0x8035
IP 0x0800
IPv6 0x86DD
PPPoE 0x8863/0x8864
MPLS 0x8847/0x8848
IPX/SPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1X 0x888E
Cluster 0x88A7
Reserved 0xFFFD/0xFFFE/0xFFFF
Protocols and standards
IEEE 802.1Q: IEEE standard for local and metropolitan area networks: Virtual Bridged Local Area
Networks
QinQ configuration task list
Task Remarks
Configuring the TPID value in VLAN tags in interface view
Optional
NOTE:
•
QinQ requires configurations only on the service provider network.
•
QinQ configurations made in Ethernet interface view take effect on the current interface only. Those
made in Layer 2 aggregate interface view take effect on the current aggregate interface and all the
member ports in the aggregation group. Those made in port group view take effect on all member ports
in the current port group.
•
Do not configure QinQ on a reflector port. For more information about reflector ports, see
Network
Management and Monitoring Configuration Guide.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points