Ensemble Designs BrightEye NXT 410 Clean HDMI Router - Manual (Page 85)

www.ensembledesigns.com Page 85
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
Operations Using a Web Control Point
You can control the BrightEye NXT through its web browser user interface to perform takes, direct
takes, gang, and gang combined with direct takes.
Prerequisites
Before you can access the Router through a web browser, you need to have access to an authenticated
Control Point and the Router’s IP address. For further details about these requirements, please see the
following sections:
• Setting Up a Web Control Point (Optional) on page 62
• Establishing Additional Web Control Points and Access Authentication on page 68
Accessing the Web Browser Control Interface
To access the NXT web browser control interface, enter the NXT’s IP address into the browser’s address
bar. The NXT’s router interface displays, showing Sources in the upper area and Destinations in the
lower area.
Performing Takes
While performing a take is a straight forward task, it can be done using more than one method.
To Perform a Take by Selecting a Source and a Destination
1. Select a Source by clicking one of the Source thumbnail images. The thumbnail frame turns red to
indicate that it is selected.
2. Select a Destination by clicking one of the Destination thumbnail images. The thumbnail frame
turns green to indicate that it is selected. As soon as you have selected both a Source and a
Destination, the Take button turns blue, indicating that the Router is ready for a Take.
3. Click Take in the lower right area of the web browser. Your chosen Source is routed to the
Destination you selected. The Destination thumbnail image updates to reflect your currently
selected Source. The Take button is now greyed out.
To Perform a Take by Selecting Only a New Source
As long as the Destination that you want is already selected, you can do a Take by selecting a new
Source, then clicking Take.
1. Leaving the Destination selection unchanged, select a new Source.
2. Click Take. Your chosen Source is routed to the Destination. The Destination thumbnail image
updates to reflect your new Source selection.