Ensemble Designs BrightEye NXT 410 Clean HDMI Router - Manual (Page 82)

www.ensembledesigns.com Page 82
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
Pressing Take
After first selecting the destination, then the source, both the Take button and the selected source
shortcut button blink to show that a Take is available. At that point, pressing Take sends the selected
source to the selected destination. The screen displays the video signal, showing the source and its
port name along the top red header and the destination and its port name along the bottom green
footer.
Performing Direct Takes
Using Direct Take mode, you can change which source is going to a
destination by pushing an assigned source shortcut button. A cross
point switch is made directly without pressing Take.
To Enter Direct Take Panel Mode
• When the BrightEye NXT is not in Direct Take mode, the Take
button illuminates blue.
• Double-tap the blue illuminated Take button. The message
“Panel Mode Direct Take” displays very briefly on the front
panel screen.
• The Take button stops illuminating.
To Make a Direct Take
The currently selected destination shortcut button illuminates bright
green. The source shortcut button that is currently going to the
selected destination illuminates bright red.
To make a direct take, press a different source shortcut button. The
source assigned to that shortcut button is immediately routed to the
already-selected destination.
To Exit Direct Take Panel Mode
• Double-tap the Take button. The message “Panel Mode
Preset / Take” displays very briefly on the front panel screen.
• The Take button illuminates blue.