Ensemble Designs BrightEye NXT 410 Clean HDMI Router - Manual (Page 63)

www.ensembledesigns.com Page 63
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
To Set the Subnet Mask
The subnet mask must be set in accordance with the size and topology
of your network. The default setting as received from the factory is
for a smaller network: 255.255.255.0. For a larger network, a typical
setting is 255.255.0.0. If in doubt, use the setting for a larger network.
1. Press the Configuration button. The top level menus display.
2. Press the down arrow button until the Network top level menu is
selected.
3. Press the right arrow button (or OK) to highlight the Address
submenu.
4. Press the down arrow button to highlight the Subnet Mask
submenu.
5. Press the right arrow button (or OK) to go to the Subnet Mask
selection submenu.
6. Using the arrow buttons, modify the fields in the Subnet Mask
submenu with an address that is compatible with your network.
7. Press OK to save the new Subnet Mask address, or press the
Configuration button to cancel.
Gateway and DNS Server Settings
Set the Gateway and DNS Server parameters according to your
network configuration. In general, these settings will be required only
in installations with extended networking requirements, such as a
remote site connected by VPN.
You can now browse to the BrightEye NXT from a computer on your
network as described in the next step.