Ensemble Designs BrightEye NXT 410 Clean HDMI Router - Manual (Page 51)

www.ensembledesigns.com Page 51
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
To Select the TSG Standard
1. Press the Configuration button. The top level menus display.
2. Use the up or down arrow buttons to select the top level menu for
TSG1 or TSG2.
3. Press the right arrow button (or OK) to highlight the Standard
submenu.
4. Press the right arrow button (or OK) to go to the Standard selection
submenu.
5. Press the up or down arrow buttons to select the Standard you
want to use.
6. Press OK to set your Standard selection, or press the Configuration
button to cancel your selection.
7. Press the Configuration button to back out of the menu one
level at a time. Or wait approximately 30 seconds until the screen
automatically returns to Operational mode.
The BrightEye NXT uses the video format selection of the Primary Test
Signal Generator to determine two system-wide parameters—System
Frame Rate, and Vertical Interval Switch Point.
To Select the TSG Pattern
1. Press the Configuration button. The top level menus display.
2. Use the up or down arrow buttons to select the top level menu for
TSG1 or TSG2.
3. Press the right arrow button (or OK) to access the top level of the
submenus.
4. Use the up or down arrow buttons to highlight the Pattern
submenu.
5. Press the right arrow buton (or OK) to go to the Pattern selection
submenu.
6. Press the up or down arrow buttons to select the Pattern you want
to use.
7. Press OK to set your Pattern selection, or press the Configuration
button to cancel your selection.
8. Press the Configuration button to back out of the menu one
level at a time. Or wait approximately 30 seconds until the screen
automatically returns to Operational mode.