To set the output timing for clean switches, To set the audio enables for clean switches, To set the audio breakaway for clean switches – Ensemble Designs BrightEye NXT 410 Clean HDMI Router User Manual
Page 47
www.ensembledesigns.com
Page 47
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
To Set the Output Timing for Clean Switches
Using the Output Timing control, you can adjust the timing of the Clean Switch relative to the genlock
reference. Setting the H and V parameters to 0 will “zero” time the Clean Switch, matching it to the
reference. Negative values will cause the Clean Switch to be early with respect to the reference;
positive values will make the Clean Switch output later in time.
To Set the Audio Enables for Clean Switches
The Clean Switch supports 16 channels (four groups) of embedded audio. In order for the Clean
Switch output to have a consistent configuration of audio, regardless of what is present on the input,
individual enables are provided for each group.
The Clean Switch output will always contain the enabled groups, but channels that are not present
in the input will simply be silent. In this way, switching between sources with differing audio
configurations will produce smooth, silent transitions.
To Set the Audio Breakaway for Clean Switches
If you need to configure the audio source for the Clean Switch you are using:
•
From the Clean Switches web interface page, make an audio source selection from the Audio
Source drop-down menu.