Ensemble Designs BrightEye NXT 410 Clean HDMI Router - Manual (Page 42)

www.ensembledesigns.com Page 42
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
Configuring Clean Switches from the
Front Panel
For the routers to switch cleanly between sources, both sources
need to be in the same standard and the Clean Switch needs to
be configured to that standard, too. For example, if you are using
1080i/50 signals, set the Clean Switch to 1080i/50. Note that if you
feed a signal to the Clean Switch that is set to a different standard
(for example, if a 525 SD signal is fed to a Clean Switch that is set to
1080i/50), the Clean Switch will output black and silence.
To Assign a Clean Switch to a Destination
1. Press the Configuration button. The top level menus display.
2. Use the up or down arrow buttons to select the top level menu for
either Clean Switch 1 or Clean Switch 2.
3. Press the right arrow button (or OK) to highlight the Assignment
submenu.
4. Press the right arrow button (or OK) to go to the Assignment
selection submenu.
5. Press the up or down arrow buttons to select the destination Port
to which you want to assign the selected Clean Switch.
6. Press OK to set your new Clean Switch assignment, or press the
Configuration button to cancel your selection.
7. Press the Configuration button to back out of the menu one
level at a time. Or wait approximately 30 seconds until the screen
automatically returns to Operational mode.
To Set the Standard for Clean Switches
1. From the Clean Switch top level menu, use the up or down arrow
buttons to navigate to the Standard menu.
2. Press the right arrow button (or OK) to go to the Clean Switch
Standard submenu.
3. Use the up or down arrow buttons to select the standard you want
the Clean Switch to use.
4. Press OK to set the standard to your new selection, or press the
Configuration button to cancel your selection.
5. Press the Configuration button to back out of the menu one
level at a time. Or wait approximately 30 seconds until the screen
automatically returns to Operational mode.