Ensemble Designs BrightEye NXT 410 Clean HDMI Router - Manual (Page 25)

www.ensembledesigns.com Page 25
BrightEye NXT 410/415/430 Compact Router Installation, Configuration and Operations Guide
Connecting the Power Supply
Each BrightEye NXT unit ships with the following power supply:
• Ensemble Designs Part Number 23600106
• Order Information: BEPS-NXT
• Input: 100-240V, 47-63Hz, 1.5A
• Output: 12V, 5.0A
Note: BrightEye NXTs must be powered by their own product-specific power supply that
comes with each unit. DO NOT use a BrightEye Spider power supply (BEPS6) or
a BrightEye Individual power supply (BEPS, ED part number 23118900) to power
BrightEye NXTs.
The boot up process takes about 40 seconds. When first applying power to the BrightEye NXT unit, the
Configuration button illuminates green for the first ten to fifteen seconds.
Connecting Ethernet for Web Control Point (Optional)
Because you can control and configure the NXT immediately upon boot-up with its built-in front
control panel, it is not required to use the Ethernet connection. However, if you want to configure one
or more web control points, you will need to network to the Ethernet port.
Use CAT5 or CAT6 cabling to connect the Ethernet port to a network Ethernet router or switch to make
it accessible to computers on your network. The Ethernet port will auto-sense cable direction, so a
cross-over cable is not needed.
RS-232 Interface Option
As an option, the BrightEye NXT routers can be equipped with cable that has a 9-pin RS-232 port
installed at the factory.