Extreme Networks BlackDiamond 8800 Series - Manual (Page 89)

Power Supply Cords for AC Power Supplies
BlackDiamond 8800 Series Switches Hardware Installation Guide 89
To avoid causing an I/O module to be powered off, do not add a 600/900 W AC PSU to an existing
BlackDiamond 8806 system running in the configuration listed above. Extreme Networks also
recommends that you avoid mixing 220 V AC and 110 V AC inputs when both 600/900 W and
700/1200 W PSUs are present in the same system. When a combination of 220 V AC and 110 V AC
inputs is applied, ExtremeXOS is designed to optimize total chassis power for each individual PSU type
but not for a mixture of PSU types.
NOTE
Extreme Networks does not recommended using the 1200 W DC PSU in combination with any Extreme Networks
AC PSU in the same BlackDiamond 8800 series system. Extreme Networks recommends that DC and AC PSU units
not be used together in the same BlackDiamond switch.
Minimum Software Requirements
In order for the system to recognize an Extreme Networks 600/900 W AC PSU, the MSM installed in
your BlackDiamond 8806 switch requires ExtremeXOS version 11.6.1 (or later). In ExtremeXOS releases
11.3.4, 11.4.2, and 11.5.1, the 600/900 W AC PSU is disabled on all chassis. In ExtremeXOS releases
earlier than those, the software does not recognize the 600/900 W AC PSU and the PSU will not be
budgeted properly, possibly resulting in PSU shutdown and/or chassis reboot.
The 700/1200 W AC PSU is supported by all versions of ExtremeXOS.
For the system to recognize the 1200W DC PSU, the MSM in your BlackDiamond 8800 series switch
must be running ExtremeXOS version 11.3 or later.
Power Supply Cords for AC Power Supplies
Extreme Networks AC PSU(s) are shipped with both 110 V AC and 220 V AC power supply cords.
Table 15 shows the maximum DC power output allowed by these power cords when used with each AC
power supply.
All power supply cords provided by Extreme Networks are designed for use only in the United States,
Canada, and Mexico. Power supply cords for use outside of North America are typically provided by a
third-party distribution center and must meet the following requirements:
● The power supply cord must be agency-certified for the country of use.
● The power supply cord must have an IEC 320 C13 plug to connect to the IEC320 C14 connector on
the power supply.
● The power supply cord must have an appropriately rated and approved wall plug applicable to the
country of installation.
Table 15: AC Power Supply Cords
Cord Type
Maximum DC Output Power
600/900 W AC PSU 700/1200 W AC PSU
110 V AC 600 W 700 W
220 V AC 900 W 1200 W