Extreme Networks BlackDiamond 8800 Series - Manual (Page 32)

BlackDiamond 8800 Series Modules
BlackDiamond 8800 Series Switches Hardware Installation Guide 32
BlackDiamond 8800 c-Series I/O Modules
The BlackDiamond 8800 c-series of I/O modules consists of the following:
● G48Tc I/O Module on page 32
● 10G4Xc I/O Module on page 33
● 10G8Xc I/O Module on page 34
● G24Xc I/O Module on page 34
● G48Xc I/O Module on page 35
CAUTION
ExtremeXOS builds earlier than version 12.1 do not support the BlackDiamond 8800 c-series modules. If you
attempt to install one of these I/O modules before upgrading the software on your MSM the module will not be
recognized by the software and it will not power up. The following error messages are similar to the messages that
may be displayed on the console or in the log. (Samples represent an unrecognized module in slot 2.)
● Console: ERROR: Unknown cardtype in slot 2 - please program the eeprom
● Log: MSM-A: Unable to read cardtype for slot 2
G48Tc I/O Module
The G48Tc I/O module ( Figure 16 ) has 48 autosensing 10/100/1000BASE-T ports that use standard
RJ-45 connectors.
Figure 16: G48Tc I/O Module
You can add an optional S-POE daughter card to the G48Tc I/O module to provide Power over Ethernet
functions in this module. With an installed S-POE card, the ports can deliver Power over Ethernet (PoE)
to an attached device, as well as the usual Ethernet connection, using a single cable. The G48Tc I/O
module supports the IEEE 802.3af PoE specification.
The default configuration of the G48Tc I/O module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
● Operate in autonegotiation mode
Module status LEDs
10/100/1000BASE-T
ports
ASP037A