Extreme Networks BlackDiamond 8800 Series - Manual (Page 112)

Installing Modules and Establishing Initial Management Access
BlackDiamond 8800 Series Switches Hardware Installation Guide 112
Figure 67: Captive Screw on a BlackDiamond 8800 Series Blank Front Panel
3 Remove the blank front panel from the front of the BlackDiamond switch (see Figure 68 ).
Figure 68: Removing a Blank Front Panel from a BlackDiamond 8800 series Switch
4 Install an I/O module or MSM in the open slot as described in “Installing a BlackDiamond 8800
Series Module” on page 102 .
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
ASP019
ASP020