Extreme Networks BlackDiamond 8800 Series - Manual (Page 146)

Repacking a BlackDiamond 8800 Series Chassis
BlackDiamond 8800 Series Switches Hardware Installation Guide 146
● Four rack-mount screws appropriate to your organization’s equipment rack
● Screwdriver appropriate to the rack-mount screws
● Original packing materials from the chassis
● Packing tape
● Nylon strapping and crimping tool
Repacking the BlackDiamond 8810 Chassis
To repack the BlackDiamond 8810 chassis:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the chassis front panel.
2 Remove all modules and power supplies from the chassis. Follow correct Extreme Networks
procedures for removing components.
3 Using four mounting screws, attach the helper bracket to the system rack immediately below the
chassis.
4 Remove the eight mounting screws that secure the chassis to the system rack.
5 On each side of the chassis, place one hand in the empty power supply bay and the other hand in
the recessed hand-hold on the back panel of the chassis (see
Figure 98 ).
CAUTION
Do not use the fan tray handle to lift or maneuver the BlackDiamond 8810 chassis. This handle is not designed to
support the weight of the chassis.
6 Slowly guide the chassis out of the system rack using the helper bracket for support.
7 Carefully lift the chassis off the helper bracket and lower it onto wood pallet (see Figure 98 ).