Extreme Networks BlackDiamond 8800 Series - Manual (Page 41)

BlackDiamond 8800 Series Switches Hardware Installation Guide 41
3 Power Supply Units for BlackDiamond 8800
Series Switches
This chapter includes the following sections:
● Overview of BlackDiamond 8800 Series Power Supplies on page 41
● Extreme Networks 700/1200 W AC PSU on page 42
● Extreme Networks 600/900 W AC PSU on page 45
● Combining Different AC PSU Models on page 47
● Extreme Networks 1200 W DC PSU on page 48
The chapter describes the power supply units used with the BlackDiamond 8800 series switches.
Overview of BlackDiamond 8800 Series Power Supplies
The BlackDiamond 8800 series switches can be powered by either AC or DC power supplies (PSUs).
AC power supplies in the BlackDiamond 8800 series switches are fully fault tolerant and load-sharing in
an N+1 configuration. For a switch using DC power supplies in an N+N configuration, each group of
power supplies can provide A/B feed redundancy for the system. After the system is properly
configured, if one PSU fails, the others will provide sufficient power to operate a fully loaded switch.
The BlackDiamond power supply units are intended for use in specific BlackDiamond switches only.
Table 8 lists the BlackDiamond 8800 series switches and their compatible power supply units.
Table 8: PSU Compatibility in BlackDiamond 8800 Series Switches
BlackDiamond Switch Compatible PSU Compatibility Notes
BlackDiamond 8806 600W/ 900W AC PSU
AND/OR
700W/ 1200W AC PSU
OR
1200W DC PSU The 700/1200 W AC PSU can be used in combination
with a 600/900 W AC PSU in the same BlackDiamond
8806 system only.
Extreme Networks does not recommended using the
600/900 W AC PSU or the 700/1200 W AC PSU in
combination with a 1200W DC PSU.
BlackDiamond 8810 700W/ 1200W AC PSU
OR
1200W DC PSU Extreme Networks does not recommended using the
700/1200 W AC PSU in combination with a
1200W DC PSU.