Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 99)

W e b S e r v e r I n t e r f a c e 3-67
The Circuit Details screen provides the following user-activated buttons:
Static Route Table Screen
Under some circumstances, it may not be necessary for a router to learn a
route using ordinary means such as RIP or OSPF. It is possible under these
circumstances for you to add a route to the route table of a router.
The Static Routes Table (Figure 3.57) is always associated with a circuit.
Access this menu by selecting the Static Routes Table from the RIP
Parameters Table on the IP Gateway Details screen.
Figure 3.57 Static Route Table Screen
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the Target network.
Next Hop IP address of the next device in the route.
Cost Cost of using that route.
Route Status Indicates whether a route is enabled or disabled.
The Static Routes Table screen provides the following user-activated buttons:
Route Details Screen
Access this menu (Figure 3.58) by clicking on the appropriate numbered link
under the “Index” column on the Static Route Table screen.
Button Function
Submit Sets any values that have been changed.
Circuit Table Returns you to the previous screen.
Button Function
Dynamic Route Table Displays all known routes.
Add New Adds a new static route.