Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 153)

V T 1 0 0 I n t e r f a c e 4-19
Parity Sets the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the asynchronous character.
Values: 1, 2
Default: 1
Current Pin Status
Shows the status of the DTE Serial port pins.
Ethernet (IP Details) Screen
If you select “Ethernet” from the Interfaces screen, you will bring up an IP
Details screen (Figure 4.12) that lets you view and/or modify the IP
parameters listed below.
Figure 4.12 IP Details Screen
Unit IP Address A unique network address assigned to this unit.
Subnet Mask Defines the network portion of the unit’s IP address.
Gateway IP Address IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier Displays a unique identifier for a specific IP address.
Ethernet Enables or disables a remote unit’s Ethernet port.
Physical Address Displays unique MAC address.