Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 25)

A b o u t t h e W A N s u i t e 7 1 0 5 1-11
rates are configured through the Web server interface or VT100 interface. The
local Supervisory port can be set to speeds of 1200, 2400, 4800, 9600, 19200,
38400, 57600, or 115200 bps. The initial default rate of the local Supervisory
port is 19200 bps.
NOTICE: For information on pinout assignments for this connector, refer to
page A-8. See Ordering Information on page A-6 for information on
cables for this connector.
The Supervisory port performs several different functions. It serves as the
VT100 interface port, providing VT100 screens. It also supports asynchronous
PPP, providing access to the Web Server interface. In addition, the
Supervisory port is an asynchronous data port. Data is encapsulated in frame
relay packets and then transmitted through a Network port.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the Supervisory service acquires the Supervisory port.
These diagnostic messages can disrupt the connected device; however, you
can configure the unit to disable their transmission.
NOTICE: A null modem (crossover) cable is required to connect a modem to the
Supervisory port.
Data Interface Module (Rear Panel)
The Data Interface Module (DIM)
−
or rear connector module
−
mates with
the associated WANsuite 7105 module and connects it to the data equipment.
As shown in Figure 1.2, the rear panel of the DIM 7105 provides the
following:
•
Two RS-232 DB-25 connectors
•
Three RJ-48C jacks
•
One 8 -pin modular 10/100Base-T Ethernet port
The two DB-25 connectors are Serial data ports (labeled DATA 1 and DATA
2 ), and the three RJ-48C jacks are Network interfaces (labeled NET 3, NET 2,
and NET 1 ).
Figure 1.2 WANsuite 7105 Rear Panel
10/100 Ethernet
The WANsuite 7105 provides one 10/100 ETHERNET interface for IP
Gateway, SNMP, and Web server access. This interface is an 8-pin modular