Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 147)

V T 1 0 0 I n t e r f a c e 4-13
The Network APS screen provides the user-activated prompts described in the
table below.
Figure 4.8 Network APS 24-Hour History
Period Period for which the APS 24 Hour History is displayed.
Timestamp Time when the historical period was completed.
Occurrences Number of times active line has been switched to standby line.
Duration Number of seconds service was provided on this line.
Status Displays the status of this line at the end of the period.
The APS 30 Day History screen and the Backup History screens include the
same parameters found on the APS 24 Hour History screen.
Performance Screens
The “Performance” prompt on the Network screen will display a
“Performance 24 Hour” screen (Figure 4.9), which display the error events
that have occurred during each 15-minute interval of the past 24 hours. At the
top of this screen is a “Performance 30 Day” prompt that will display the
error events that have occurred during each interval (day) of the past 30 days
(Figure 4.10).
In addition to the error parameters found in the Error Status and Alarm
Thresholds Table on page 4-9, the following error parameters are included on
the Performance screens:
Prompt Function
Clear Primary Events Clears the primary line APS events and counts.
Clear Backup Events Clears the backup line APS events and counts.
Primary History Displays the primary line history of APS activity in 15-
minute buckets for the past 24 hours (Figure 4.8).
Backup History Displays the backup line history of APS activity in 15-minute
buckets for the past 24 hours.