Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 85)

W e b S e r v e r I n t e r f a c e 3-53
NOTICE: If you change a Service parameter, you must click on Submit to see the
appropriate DLCIs.
The Service Aware screen provides a “Clear Alarms” user-activated button at
the bottom of the screen.
Rule Details Screen
Use the Rule Config screen (Figure 3.46) to establish Service Aware
parameters. To access the screen, click on the appropriate number under the
“Index” column on the Service Aware screen. To establish a rule, you must
select the desired rule configuration options and provide the appropriate filter
information where required. Then press the “Submit” button at the bottom of
the screen.
Figure 3.46 Rule Details Screen
The paragraphs below describe the Rule Details screen parameters and their
options.
Service Selects the service to which the rule applies. Select from a pull-down list of
available services.
NOTICE: If you change a Service parameter, you must click on “Submit” to see
the appropriate DLCIs.
DLCI Selects the DLCI to which the rule applies. Select from a pull-down menu
that lists applicable DLCIs.
Filter By DLCI Enables or disables filtering of the IP traffic by the DLCI specified in the
DLCI pull-down list.