Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 219)

V T 1 0 0 I n t e r f a c e 4-85
As soon as you initiate generation of a report by pressing the “Enter” key or
the “Start” prompt, the Duration value is copied over to the Time Remaining
field. As soon as the specified Duration for the report has elapsed, the
resulting report-specific information will be displayed on the right side of the
screen. This report comprises elements as defined below.
Report # Displays a unique number used to identify the generated report. This number
is generated automatically, is incremented sequentially for each report, and
can be used by management stations for automatic polling (via the
ipadv2.mib).
Size Displays the actual number of IP addresses identified as Top Talkers in the
generated report. The maximum report size is 20.
Start Time Displays the time at which the Top Talkers report was initiated (based on
System Up Time).
System Up Time Displays the amount of time that the unit has been operational since it was
turned on or last reset.
The Top Talkers table reports in descending order the IP addresses that have
generated the most traffic during the requested report’s duration. For each IP
address listed, the report displays the number of Rx frames, Rx octets, Tx
frames, and Tx octets that have been passed across it. In addition, the
Timestamp field indicates the time at which a packet was examined for the
specified IP address.
Originate Ping
The WANsuite 7105 Originate Ping function helps telephone companies
determine if a network is properly configured and also helps them maintain
SLAs.
Originate Ping Screen
The Originate Ping Screen (Figure 4.80) lets you set the parameters described
below.