Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 179)

V T 1 0 0 I n t e r f a c e 4-45
If this parameter is set, a PC connected to the LAN interface of this
WANsuite 7105 can reach a remote WANsuite 7105 through this DLCI. The
remote IP address must be part of an IP network that is different from the
local WANsuite 7105, and the local WANsuite 7105's IP address must be
configured into the PC. This way, local and remote WANsuite 7105s can be
reached regardless of the availability of the routers connected at the back of
the WANsuite 7105s.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to “Switched.” Set the type to “Local”
if this DLCI will be used for management purposes only.
Values: Switched, Local
Default: Switched
Delete Endpoint You may delete any endpoint.
Endpoint Service Details Screen
Selecting from the column on the Endpoint Table screen displays the
typical Service Details screen (page 4-23) in which you can view, and in
some cases change, parameters including Index, Interface, Type, and Pair. A
Delete Service prompt is also included on this screen.
DLCI Details Screen
The DLCI Details screen (Figure 4.38) lets you access the configuration
parameters described in the following paragraphs. To bring up this screen,
select any DLCI from the column on the Endpoint Table screen.