Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 174)

4-40 W A N s u i t e 7 1 0 5
Figure 4.32 SCADA Service Details Screen
Message Size Maximum number of characters to buffer before sending a frame.
Values: 0
−
1024
Default: 256
Idle Character Delay Maximum number of idle character time to wait before sending a frame.
Values: 0
−
65535
Default: 10
Input Terminator Decimal value of the character that terminates a message before sending a
frame.
Values: 0
−
255
Default: 0
Data Direction Data direction that the port will support. If set to “Input,” the port will only
accept incoming data and will not transmit data. If set to “Output,” the port
will ignore any incoming data. If set to “Both,” the port will process all data.
Values: Input, Output, Both
Default: Both
SCADA Loopback Determines if and where SCADA will loopback received data.
Values: None, Loopback to Network, Loopback to Port
Default: None
The table below these parameters displays the SCADA statistics. You can
clear all SCADA statistics by selecting the “SCADA Clear Statistics” prompt
at the bottom of the screen.
Select the “SCADA Device List” prompt to bring up a screen that shows the
mapping between SCADA devices and endpoints (Figure 4.33).