Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 157)

V T 1 0 0 I n t e r f a c e 4-23
4-23) by selecting from an entry under the “Index” column (Service Details),
the column (Interface Details), or column (Type Details).
To add a service, select the “Add Service prompt at the top of the screen.
Data Line Monitor Table
Select the Data Line Monitor prompt at the top of the Service Table screen to
view a screen that displays SCADA port information (Figure 4.17).
Figure 4.17 Data Line Monitor Table
Service Enable and
Disable
Displays whether capture is Enabled or Disabled.
Tx/Rx Filter Displays the direction of the captured data.
Pattern Filter Enable Displays the Filter for the pattern being searched and captured.
Pattern Displays which specific pattern is being searched for.
Mask Displays the bits the unit is looking for.
Offset Displays the offset in the packet that matches the pattern.
You may view the captured data in the Data Monitor Packet Table screen
(Figure 4.18) by selecting the “Packet Capture” prompt at the top of the Data
Line Monitor screen. The screen shows about 10 lines of active data, and if a
line is selected, the screen will display further decoded data below.