Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 37)

W e b S e r v e r I n t e r f a c e 3-5
Interfaces
The WANsuite 7105 has the following interfaces: Network 1, Network 2,
Network 3, Serial 1, Serial 2, 10/100 Ethernet, and Supervisory. Each of the
interfaces and their associated screens/menus are described below.
Network Screens
The Network 1 (shown below in Figure 3.4), Network 2, and Network 3
screens offer the same parameters except for the following: the “Function”
parameter is found only on the Network 2 screen (top portion shown in Figure
3.5), and the “Timing” parameter is not included on the Network 3 screen
(top portion shown in Figure 3.6). Because APS is configured in the Network
2 screen only, there is an additional user-activated button, “Network APS,” on
the Network 2 screen that does not appear on either the Network 1 or
Network 3 screen. All three Network ports operate in the long-haul or short-
haul mode. The Network screens let you view and make changes to the
Network interface's configuration as described below. In addition, these
screens provide a table that displays the alarm values for the Network
interface.
Figure 3.4 Network 1 Screen