Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 43)

W e b S e r v e r I n t e r f a c e 3-11
the Primary line is inhibited from carrying service. If set to “Backup,” the
Backup line is manually inhibited from carrying service.
Values: Disabled, Primary, Backup
Default: Disabled
Revert If disabled, service does not return to the primary line until the backup line
fails. If enabled, service automatically returns to the primary line when the
primary line is able to carry service again.
Values: Disable, Enable
Default: Disable
Network APS Status Table
In addition to the configurable fields listed above, the Network APS screen
displays a table that lets you set specific thresholds and view the Primary and
Backup Line status for other parameters listed below.
Status Indicates the status of the specified line. The status can be “Disabled” if the
Network APS function is not enabled on the Network 2 configuration screen.
Otherwise, the line status is either “Active” or “Stand-By” with any of the
following qualifiers appended: /Failed, /Inhibit, or /LB. The /Failed qualifier
is appended when the carrier fails or when either the Errored Seconds or
Consecutive Severely Errored Seconds threshold is reached. The /Inhibit
qualifier is appended when the Errored Seconds threshold or Consecutive
Severely Errored Seconds is manually inhibited or when the far end inhibits
the line. The /LB qualifier is appended when the line is in a loopback test.
ES Threshold Sets the number of errored seconds in a 15-minute period before a transfer
request is triggered. Setting the threshold value to zero disables this event
from causing a line transfer.
Values: 0
−
900 s
Default: 20 s
ES Count Indicates number of errored seconds in the current 15-minute historical
interval. This count is cleared at the beginning of a new 15-minute historical
interval. It is also cleared whenever the line becomes available to carry
service.
ES Switch Event Indicates if an exceeded ES threshold has caused a transfer to the standby
line.
CSES Threshold Sets number of consecutive severely errored seconds before a transfer request
is triggered. Setting the threshold value to zero disables this event from
causing a line transfer.
Values: 0
−
900 s
Default: 2 s
CSES Count Indicates number of consecutive severely errored seconds in the current 15-
minute historical interval. This count is cleared whenever a non-severely
errored second occurs.