Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 154)

4-20 W A N s u i t e 7 1 0 5
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
NOTICE: To use newly established IP parameters, you must “Save and Restart.”
(See Save and Restart on page 4-6.)
Select the Unit Access Table prompt on the Ethernet (IP Details) screen to
view the Unit Access Table (Figure 4.13), which specifies up to 10 different
IP networks that may access the unit. If no IP networks are supplied, any host
can access the unit. Select an number on the table to view the Unit
Access Details (Figure 4.14) that correspond with that number.
Figure 4.13 Unit Access Table
Figure 4.14 Unit Access Details