Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 112)

3-80 W A N s u i t e 7 1 0 5
TCP Connection Timer The maximum time (in seconds) NAT will use resources when attempting to
establish a TCP connection.
Values: 0
−
65535
Default: 300
TCP Closing Timer The maximum time (in seconds) NAT will use resources when attempting to
close a TCP connection.
Values: 0
−
65535
Default: 0
TCP Disconnected
Timer
The maximum time (in seconds) NAT will use resources when attempting to
disconnect from TCP.
Values: 0
−
65535
Default: 120
TCP Sequence Delta
Timer
The maximum time (in seconds) NAT will use resources when managing TCP
Packet Sequencing.
Values: 0
−
65535
Default: 180
UDP Timer The maximum time (in seconds) NAT will use resources for a UDP port in
use.
Values: 0
−
65535
Default: 120
ICMP Timer The maximum time (in seconds) NAT will use resources for any ICMP
request.
Values: 0
−
65535
Default: 120
The NAT Details screen provides the following user-activated buttons:
Static TCP Translation Table Screen
The Static TCP Translation Table screen (Figure 3.74) allows static mapping
of global TCP Server ports to a local host IP address/port combination. The
parameters described below enable access to TCP servers on the private/
Button Function
Submit Sets any values that have been changed.
Static TCP Translation Table Allows static mapping of global TCP Server ports to
a local host IP address/port combination.
Static UDP Translation Table Allows static mapping of global UDP Server ports to
a local host IP address/port combination.
NAT Port Table Defines NAT global/Internet and local/corporate
ports.