Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 44)

3-12 W A N s u i t e 7 1 0 5
CSES Switch Event Indicates if an exceeded CSES threshold has caused a transfer to the standby
line.
Availability Timer Minimum amount of time free of errors during active events that must expire
before this line is returned to service availability.
Values: 0
−
900 s
Default: 900 s
The Network APS screen provides the user-activated buttons described in the
table below.
Figure 3.8 Network APS 24-Hour History
Period Period for which the APS 24 Hour History is displayed.
Timestamp Time when the historical period was completed.
Occurrences Number of times active line has been switched to standby line.
Duration Number of seconds service was provided on this line.
Status Displays the status of this line at the end of the period.
The APS 30 Day History screen and the Backup History screens include the
same parameters found on the APS 24 Hour History screen.
Performance screens for Network interfaces other than APS are shown below.
Button Function
Submit Sets any values that have been changed.
Clear Primary Events Clears the primary line APS events and counts.
Clear Backup Events Clears the backup line APS events and counts.
Primary History Displays the primary line history of APS activity in 15-
minute buckets for the past 24 hours (Figure 3.8).
Backup History Displays the backup line history of APS activity in 15-minute
buckets for the past 24 hours.