Verilink WANsuite 7105 (34-00316.C) Product Manual - Manual (Page 155)

V T 1 0 0 I n t e r f a c e 4-21
Supervisory Configuration Screen
The Supervisory Configuration screen (Figure 4.15) displays the current speed
of the Supervisory port interface, and other asynchronous parameters as
described below. The Supervisory port supports only asynchronous character
formats.
Figure 4.15 Supervisory Configuration Screen
The Supervisory screen lets you view and change the Supervisory port speed.
The Supervisory port only supports async character formats.
Speed Used to change the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Character Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Parity Sets the parity bit.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
DTR Alarm Control Choices for DTR Alarm Control are “Enable” and “Disable”; the default
setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit
to generate an alarm upon loss of DTR, which occurs when the Serial port
detects that the DTR signal is low.
Values: Enable, Disable
Default: Disable
DTR Alarm Status Lets you view the current DTR Alarm status.