Teac HS-2 - Manual (Page 93)

TASCAM HS-2
93
D-IN button:
Synchronize with the clock of the digital signal
selected as the input for DIGITAL IN.
You cannot select an input as the master clock if the
sampling rate converter is ON for that input.
On the second line of the button, the digital input
signal selected is shown.
NOTE
• A mark appears on the button of the currently
active master clock.
• If synchronization from an external clock is interrupted,
the unit’s internal clock becomes active. In this case,
the mark appears on the
INT
button to show that it
has become the active clock, and the mark appears
on the button of the selected external clock that was
lost.
SYNC page
Make settings related to synchronization on this page.
NOTE
If the Option SY-2 has not been installed, the display is
shaded and the setting cannot be selected.
STATUS
Shows the status of the currently loaded project’s
sampling frequency and clock synchronization.
TC Chase
Use to turn playback synchronized with timecode
ON
or
OFF
(default).
Set it to
ON
when you want to match the timing of
this unit’s audio with a timecode master device (audio
recorder, video or built-in time code generator).
You can also set timecode offset (TC Offset) with the
timecode master device. Touch the
EDIT
button to
open the
CHASE Offset
screen where you can set the
offset value in a range between −
23:59:59.29
and
+
23:59:59.29
(default:
00:00:00.00
).
NOTE
TC Chase
can also be turned
ON
and
OFF
by pressing the
SHIFT and CALL keys at the same time.
TC Rechase
Turn this function, which re-synchronizes when synchro-
nization with timecode becomes inaccurate,
ON
or
OFF
(default).
When set to
OFF
, after synchronizing once, input time
code is ignored and the unit operates in free run mode.
When set to
ON
, set the amount of inaccuracy that triggers
rechasing.
To set the amount of inaccuracy that triggers rechase,
touch the knob and turn the DATA dial to select a value in
frames of
1/3
,
1
,
2
(default),
5
or
10
.
Master TC
Set whether the unit synchronizes with the built-in
timecode generator or with timecode input from another
device.
Internal button:
Synchronize with the built-in generator.
External button (default):
Synchronize with timecode input from another device.
10–Internal settings