Teac HS-2 - Manual (Page 23)

TASCAM HS-2
23
l Time display area
The times displayed in each region depend on the
time display mode as shown in the following table.
Left end Right end
00:00:00:00 Total take or entry length
Total take or entry length 00:00:00:00
00:00:00:00
Total session or playlist
length
Total session or playlist
length
00:00:00:00
Starting time of session or
playlist
Ending time of session or
playlist
During recording and recording standby, however, the
time bar and division lines are not shown.
; Flash Page number and knob
This shows the Flash Page number. Touch this area to
enable selection (yellow background), and turn the
DATA dial to change the page number (turn right to
increase and turn left to decrease).
z Current time cursor
This cursor shows the playback position and scrolls
horizontally in correspondence with the time counter.
It is not shown during recording (take mode only).
x Mark name
This is the name of the mark at the current time or the
nearest preceding mark.
When the name of a mark other than any automatic
mark is shown, touch this area to open the MARK
NAME editing screen.
c INPUT MONITOR button
This is the same as on the Home Screen in timeline
mode.
v EDIT button
Touch this button to open a pull-up menu for take
editing.
b NEXT TAKE NAME button
This is the same as on the Home Screen in timeline
mode.
2−Names and functions of parts