Teac HS-2 - Manual (Page 28)

28
TASCAM HS-2
• When the LCD Section
is set to
LOCK
:
• If the display is touched, the following pop-up
message appears when the display (panel) is locked.
Display (panel) locked
• If one of the keys around the display is pressed,
the following pop-up message appears when the
display (keys) is locked.
Display (key) locked
• When Transport
is set to
LOCK
, if one of the transport
keys is pressed, the following pop-up message appears
when the transport is locked.
Transport locked
• When REMOTE/KEYBOARD
is set to
LOCK
, if a remote
control or keyboard connected to a remote connector
is used, the following pop-up message appears when
remote/keyboard control is locked.
Remote/Keyboard control locked
• When EXTERNAL CONTROL
is set to
LOCK
, if an
operation is conducted using RS-232C, RS-422,
PARALLEL or ETHERNET, the following pop-up message
appears when external input is locked.
Remote/Keyboard control locked
Recording times
The table below shows the total amount of recording time
(in hours and minutes) possible on SD cards/ CF cards of
various capacities for each available recording format.
File recording format
Card capacity
8 GB 16 GB 32 GB
16-bit, 44.1 kHz 12:34 25:10 50:21
16-bit, 48 kHz 11:32 23:07 46:16
24-bit, 44.1 kHz 8:22 16:46 33:34
24-bit, 48 kHz 7:41 15:24 30:50
24-bit, 88.2 kHz 4:11 8:23 16:47
24-bit, 96 kHz 3:50 7:42 15:25
24-bit, 176.4 kHz 2:05 4:11 8:23
24-bit, 192 kHz 1:55 3:51 7:42
• The recording times shown above are estimates. They
might differ depending on the card in use.
• The recording times shown above are not continuous
recording times, but rather they are the total possible
recording times for the card.
3−Preparation