Teac HS-2 - Manual (Page 91)

TASCAM HS-2
91
NOTE
Audio Over
occurs when the level exceeds the
maximum level (full scale) minus the value set by the
user. (In the example above, this would be when the level
exceeds the maximum level minus 0.20 dB.)
NOTE
The
PRE/REC/END
auto marker is only recorded into
takes in take mode, and does not appear on the timeline
in timeline mode.
NOTE
After an
Audio Over
or
Sync Unlock
auto marker has
been placed, the same type of mark is not repeated until
at least 10 seconds has passed.
Playback settings (PLAY SETUP)
Use this screen to make settings related to playback.
GENERAL page
Make various settings related to the playback mode on
this page.
Play Mode
Set how the playback of takes and entries is handled
using the following buttons. This setting affects all modes
except timeline mode.
One Take button (default):
Only the currently selected take or playback is
played back.
All Take button:
All the takes in the currently loaded session or all
the entries in the playlist are played back.
Repeat Mode
Turn repeat playback
ON
and
OFF
(default).
CONTROL page
Make various settings related to the playback functions
on this page.
Auto Cue
Turn the auto cue function
ON
or
OFF
(default). If auto cue
is
ON
, whenever a take is changed or loaded, the unit will
enter playback standby at the point where sound first
starts in the take. When
Play Mode
is set to
One Take
and no sound is detected before the end of the take, the
unit stops at the start of the take. When
Play Mode
is set
to
All Take
and no sound is detected before the end of
the take, the unit continues detection in the next take.
This setting affects all modes except timeline mode.
To set the auto cue start point detection level, touch the
knob area and use the DATA dial to change the value.
Options:
–72dB
,
–66dB
,
–60dB
,
–54dB
(default),
–48dB
,
–42dB
,
–36dB
,
–30dB
,
–24dB
10–Internal settings