Teac HS-2 - Manual (Page 92)

92
TASCAM HS-2
Auto Ready
Turn the auto ready function
ON
or
OFF
(default).
If auto ready is
ON
, when playback of a take completes the
unit automatically stops at the beginning of the next take.
This setting affects all modes except timeline mode.
Inc. Play
Turn the incremental play function
ON
or
OFF
(default).
When incremental play is
ON
, press the PLAY key during
playback to move to the beginning of the next take and
continue playing, or press the STOP (RETAKE) key during
playback to move to the beginning of the next take and
pause playback.
This setting affects all modes except timeline mode.
PLAY Inhibit Time
This sets a time interval during which playback of the
same take (entry) cannot be restarted.
The following keys and commands are disabled (excluding
flash start keys/commands for other takes/entries) for the
duration of this setting. The following keys and commands
are disabled (excluding flash start keys/commands for
other takes/entries) for the duration of this setting. The
PLAY key on the front panel of the unit, the PLAY key,
flash start keys and fader start function of the TASCAM
RC-HS20PD remote control (sold separately), and play and
flash start commands from external controllers (RS-232C/
RS-422/ Parallel/ Keyboard).
Setting range:
0–1000
msec (100 msec intervals),
Inf
(during playback the affected keys are disabled for this
amount of time)
Default value:
0 msec
NOTE
When the
PLAY Inhibit Time
item is set to
Inf
, the
incremental play function is automatically fixed to OFF
and cannot be switched to ON.
Sync and time code settings (SYNC T/C)
Make various settings related to audio synchronization
and time code on this page.
This screen has five pages:
CLOCK
,
SYNC
,
T/C
,
SETUP
and
I/O
. Touch the tabs at the bottom of the screen to open
the corresponding page.
CLOCK page
View various clock status information and select the clock
used for synchronization.
STATUS
Project:
Displays the sampling frequency of the project.
CLOCK:
Displays the clock synchronization status.
WORD/VIDEO:
Displays
WORD
,
VIDEO
or
TriLevel
if such a signal
is detected at the input.
D-IN:
Displays the digital input signal status as shown in
the following table:
Digital input signal status Display
Locked Locked (xx.xxx kHz)
When sampling rate conversion
is ON
Locked (xx.xxx kHz
FsCnv)
Unlocked Unlocked (xx.xxx kHz)
No signal Unlocked (no signal)
No audio signal present Not Audio
Other Cbit information differs
from the actual operation mode
Unmatched Cbit
MASTER
Use the buttons to select the master clock to use.
INT button (default):
Use this unit’s internal clock.
WORD button:
Synchronize with the word clock input through the
WORD/VIDEO IN connector.
VIDEO button:
Synchronize with the video clock input through the
WORD/VIDEO IN connector.
10–Internal settings