Teac HS-2 - Manual (Page 87)

TASCAM HS-2
87
Playback control in playlist mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP (RETAKE) key to stop playback.
Press the
. [MARK . ] key or / [MARK / ] key
to switch entries.
Press and hold the m [
] key or , [ ] key to
search backward or forward.
Press the
. [MARK .
] or
/ [MARK /
] key while
pressing and holding the SHIFT key to move between
marks.
Press and hold the m [
] key or , [ ] key
while pressing and holding the SHIFT key to search at
high-speed.
NOTE
• On the PLAY SETUP
screen, you can set whether only
the currently selected entry is played or whether all the
entries within the current playlist are played. You can
also enable and disable repeat playback. (See “Playback
settings (PLAY SETUP)” on page 91.)
• Playback functions can also be used via parallel control.
Using the call function in playlist mode
Press the CALL (CHASE) key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.
Using the flash start function in playlist mode
Using a TASCAM RC-HS20PD (sold separately) or other
remote controller, flash start playback is possible.
For details, see “Flash start function” on page 113.
9–Playlist mode